curing speed造句
例句與造句
- While the curing speed of intra - gallery was slower than that of extra - gallery , exfoliation never happened
當蒙脫土層間的固化速度小于層外固化速度時，則不能。 - By variation of curing agents of epoxy and modifier of clay , the different curing speed of intra - gallery and extra - gallery could be obtained
通過調節有機插層劑和固化劑，可以獲得不同的層間和層外的固化速度。 - The resin produced by the flame - retardant products with high strength and mechanical properties , thermal deformation temperature , curing speed , and good soak
該樹脂所生產制品具有很高的阻燃性能和機械強度，熱變形溫度高，固化速度快，浸透性好。 - Cure speed is fast . the time of initial cure is only 5minutes also in summer , 8 - 10minutes in winter . after 30minutes , the strength up to 80 % . post cure for 24h
硬化時間迅速，夏天5分鐘左右即可初期固定，冬天則延至8 - 10分鐘， 30分鐘后可達80 %強度， 24小時后達到全力。 - Results showed that temperatures have different effects on the curing speed of resin , the rate of moisture transmission , the degree of plastic melting and the degree of wheat straw decomposition
結果表明，熱壓溫度對板坯中膠黏劑的固化速度、水分傳遞速度、塑料熔融程度、麥秸分解程度等都有不同程度的影響。 - It's difficult to find curing speed in a sentence. 用curing speed造句挺難的
- Xt - p1007 unsaturated polyester resin is reactive flame retardant resin , heat distortion temperature , curing speed , good soak and toughness , both major requirements for flame - retardant and high mechanical strength requirements pultruded products
P1007不飽和聚酯樹脂是反應型阻燃樹脂，熱變形溫度高，固化速度快，優良的浸透性和韌性，主要應用于既要求阻燃又要求機械強度高的拉擠產品。 - It was found that exfoliation of clay occurred when the curing speed of intra - gallery was faster than that of extra - gallery even the epoxy / clay compositions were cured at any temperatures , for any time and with any types of curing agents
研究表明，當蒙脫土層間的固化速度大于層外固化速度時，采用不同的固化劑，固化不同時間，在不同的溫度下固化都可以得到剝離型的環氧/蒙脫土納米復合材料。